put all stalks in, mini-stalk in, pin in hte spring mechanism and screw bolt into case(3rd small stalk w/1 "gear" on it), then put the little "guy"(shift selectors) on the sliding gear selectors. Allow it to sit in place so ti doesn't move, then RTV the case end and put the other side of the case on.
once the case is in place, take the 4 pins(2 top, 2 bottom) and use your hand through the selector shaft hole to carefully align them and place the pins through the bearings on the actual selector arms. You'll see when you're in there. Once you have ALL 4 in, then continue putting the rest of the bolts in.
I see you've dismantled the 5th gear selector gear.. good luck getting that working again. That shit sucks when the little teeth come out.
EDIT: 1 pic I have of 3rd small shaft in place....
